IAC-IAC –S In line Circulator pumps:

The IAC pumps are Centrifugal, single-stage, with suction and discharge in-line, one opposite the other, in monoblock construction for horizontal or vertical mounting.

  • Description
  • Pedir información sobre este producto

Description

The IAC pumps are Centrifugal, single-stage, with suction and discharge in-line, one opposite the other, in monoblock construction for horizontal or vertical mounting.
The models can be rationalized using the most appropriate pump for each problem, thus optimizing energy consumption and giving long life to the equipment.

Impeller: closed type with double curvature blades for high efficiency. Balanced both statically and dynamically, favoring long life for the bearings.
Flanges: The suction and discharge connections are fitted with flanges. These are of a nominal pressure PN-10 as per DIN 2532.
Motor: IEC standard motors, 230/400 V 50 Hz. Protection IP-54. On demand it is possible to supply motors with other voltages and specials such as ATEX.
Materials: The standard construction is cast iron GG-20. The hydraulic design follows the standard DIN 24255 for pumps for general supplies pumps. It makes it possible to rationalize the models and use the most appropriate pump every time, thus optimizing the energy consumption, and allowing a long life to the equipment.

Standard normalized mechanical seal: ceramic/graphite.
Temperature of the liquid from -10° C to +100° C.
Max. room temperature: +40° C.

  • IAC series with shaft in AISI-316 and rigid coupling to the motor.




I accept the terms of use and I have read the privacy policy of Bombas Elias *

captcha